Tips and Information about making jewelry



With this blog, I hope to share my knowledge, successes, trials and errors, student's work, tips, and information about making jewelry.

Sunday, March 23, 2014

Bench Tips Straightening Wire & Picking up Small Stones



I’d like to pass on some tips I use when working with metal or setting stones. Have you ever had a small piece of wire you wanted to use but it was all bent out of shape? Well here is a tip on how to make it straight again!
Bend it as straight as you can using flat-nose pliers. Place the wire on a smooth anvil or steel block with another anvil or smooth steel block over the wire. Slide the top block back and forth across the bottom one keeping the wire between the blocks. The wire rolls along straightening out as it rolls! Also, this is a great way to work-harden the wire!








Have you had a hard time picking up tiny stones while placing them into a setting? Roll some bee’s wax between your fingers into a point. Now use the point to pick up the small stone. To remove the stone from the wax, place it into the setting and roll the tip of the wax away from the stone. To clean the wax off the stone wipe it with a towel after setting it. If you plan to fire the stone in place, the wax burns off cleanly in the kiln.









Found on the model isle
Additionally, there is a product I found at Hobby Lobby called Pic- n- Stic. It works the same way for holding stones.

Holds without leaving residue

2 comments: